Quick Summary
To prevent frozen pipes in Pasco, keep indoor air at 65 degrees Fahrenheit or higher day and night, even when the home is unoccupied. Open cabinet doors under sinks on outside walls, and wrap exposed pipes with foam insulation sleeves.
- Set the thermostat to at least 65 degrees, including when nobody is home.
- Open cabinet doors under sinks on outside walls so warm room air reaches the pipes.
- Wrap exposed pipes with foam sleeves and use UL-listed heat tape where needed.
- On nights near freezing, let a pencil-thin stream run from the faucet on the most vulnerable pipe.
- Find and test your main shut-off valve before the first cold night.
Table of Contents
- Why Pasco Pipes Freeze Even in a Mild Winter
- Minimum Temperature to Keep Pipes From Freezing in Winter
- Step 1: Set the Thermostat and Open Cabinet Doors
- Step 2: Protect Pipes on an Outside Wall and Exposed Lines
- Step 3: Drip Faucets and Decide Whether to Shut Off Water
- Keeping Pipes From Freezing Without Heat
- Booking a Plumbing Inspection Before the Cold Arrives
- Frequently Asked Questions
Why Pasco Pipes Freeze Even in a Mild Winter
Pasco County sees mild winters most years, but frozen pipes still happen here more often than most homeowners expect. A single night dipping below freezing can be enough.
Water expands as it freezes, and that expansion puts real pressure on the pipe walls.
A common mistake is assuming Florida weather means no freeze risk.
The Chubb guidance on protecting unoccupied properties recommends treating any unheated space as a freeze risk, which applies to many Pasco outbuildings and seasonal rentals.
For a full breakdown of the physics and which pipes are most at risk, read why pipes burst in winter and how to prevent it.
Minimum Temperature to Keep Pipes From Freezing in Winter
Keep indoor air at or above 65 degrees Fahrenheit to protect pipes from freezing. This applies even when nobody is home, especially in outbuildings and second homes.
The Chubb recommended temperature setting for vacant properties advises the same 65-degree minimum for unoccupied homes. Mini-split systems can help here. Some units offer a freeze guard mode that keeps the space at a safe temperature while you are away.
Watch out: a thermostat set to 65 degrees does not protect a pipe that sits against a cold exterior wall. Air temperature near the pipe matters more than the reading on the wall.
Step 1: Set the Thermostat and Open Cabinet Doors
Start indoors. Set the thermostat to at least 65 degrees, then open cabinet doors under sinks on exterior walls so warm room air reaches the pipes. This takes about two minutes and costs nothing.
Keep these steps simple:
- Set the thermostat to 65 degrees or higher, day and night
- Open cabinet doors under kitchen and bathroom sinks on outside walls
- Move cleaning supplies and chemicals out of the way so the lines stay clear
- Leave interior doors open to help heat move through the house
Many people skip this step because it feels too small to matter. It takes minutes, and it works best when combined with the steps that follow.
The steps below are the ones the article describes, with the timing or frequency it gives for each.
Step What to do Time or frequency Set thermostat Set to 65 degrees or higher Day and night Open cabinets Open doors under sinks on outside walls Takes about two minutes Clear chemicals Move cleaning supplies out of the way Before cold arrives Open interior doors Let heat move through the house Ongoing Step 2: Protect Pipes on an Outside Wall and Exposed Lines
Pipes on exterior walls and in unheated spaces need direct protection. Wrap them with foam pipe insulation sleeves, which are inexpensive and available at most hardware stores.

Homeowner wrapping foam insulation around exposed copper pipes to prevent frozen pipes on an outside wall. Heat tape or heat cable is an option for pipes that stay exposed no matter what. Choose a product labeled as UL-listed and follow the manufacturer’s instructions closely.
Seal gaps where pipes enter the house. Cold air often comes through small openings around the pipe, and caulk or expanding foam closes them.
Hose bibs and outside spigots need attention too.
Step 3: Drip Faucets and Decide Whether to Shut Off Water
On nights when temperatures drop near freezing, let faucets drip slowly. Running water keeps the line moving, which makes it harder for ice to form and block the flow. Open the faucet served by the pipe most at risk, usually one on an exterior wall.
Shutting off water to a vacant home is a different decision. Turning off the main valve and draining the lines removes the risk of a burst while nobody is home. This works well for seasonal properties. Will shutting off water keep pipes from freezing? It can, but only if you drain the lines completely afterward.
Find and Test Your Main Shut-Off Valve Now
Most guides assume you already know where your main water shut-off valve is. Many homeowners do not, and that gap turns a small leak into a flooded floor. Find it before the first cold night.
- In most single-family homes, the main valve sits where the water line enters the house, often near the water heater, in a utility closet, or at the meter box near the street.
- In a garage or crawl space, look for a lever handle on the line coming through the foundation wall.
- If you are on a private well, the main shut-off is usually on the pressure tank or the line leaving it.
Test the valve while the water is running at a sink. Turn the handle clockwise until it stops, confirm the flow at the sink drops to nothing, then open it back up. A valve that will not close fully or that drips when shut is a repair item, not a maybe. Label the valve with a tag so anyone in the house can find it in the dark.
What to Do If a Pipe Freezes
If a faucet runs to a trickle or stops entirely on a cold morning, assume a line is frozen before you assume a supply outage.
Watch out: never use an open flame, a blowtorch, or a charcoal grill to thaw a pipe, and never pour boiling water on a line inside a wall. Those methods start fires and can crack the pipe.
If you cannot find the frozen section, or if a pipe has already split, shut off the main valve immediately and call a licensed plumber. A split line can spray water the moment it thaws, so turning off the supply first limits the damage.
Insurance and Liability: What a Burst Pipe Actually Costs You
Homeowners policies vary, and coverage for water damage depends on the policy terms. Review your policy with your insurance agent to understand what is covered.
That makes your records matter. Keep receipts for insulation, heat tape, and any inspection, and note the date you set the thermostat or shut off the water before a trip. If you rent out a seasonal property, check whether your policy treats an unoccupied home differently, since many policies shorten the window before vacancy exclusions apply.
Smart Monitoring That Catches a Freeze Before It Bursts
A thermostat set to 65 degrees does not tell you when the temperature near a pipe in the garage drops below freezing. Modern leak detectors and smart thermostats close that gap.
A newer option is an automatic shut-off valve that clamps the main line closed when a sensor detects a leak. These cost more than a sensor alone and need a plumber to install, but they turn a burst pipe into a wet spot instead of a flooded house.
Keeping Pipes From Freezing Without Heat
When the power goes out, the home loses its heat source and the risk rises quickly. How fast depends on the outdoor temperature and how well the house holds heat. On a night in the 20s, an unheated garage or crawl space can drop to freezing within a few hours, while the living space usually holds warmth much longer. That difference is why the pipes in unheated spaces are the first to go.
A Power-Outage Plan That Actually Works
Work through these steps in order when the heat stops:
- Drip the faucets served by exterior-wall and unheated-space pipes, as described above. Moving water resists freezing longer than still water.
- Open cabinet doors under sinks on outside walls so room air reaches the pipes.
- Close off unused rooms and keep the family in the smallest practical area. Concentrating people and any safe heat source in one zone keeps that zone warmer.
- If you have a gas or wood-burning fireplace that is safe to use, it can keep the core of the house above freezing. Never use a charcoal grill, a camp stove, or a generator indoors; carbon monoxide kills people in exactly this situation.
- If the outage is forecast to last more than a day and you cannot keep the home above freezing, shut off the main valve and drain the lines. A drained system cannot burst.
For short outages, dripping and insulation are often enough. For longer ones, draining the system is the safer choice. If you leave the home during an outage, shut off the water before you go.
Space Heaters: Useful, but the Wrong Tool for Pipes
Some people use space heaters as a backup. Use them carefully, keep them at least three feet from anything flammable, and never leave them running unattended. A space heater in a garage can keep a pipe above freezing, but only if it is rated for the space and plugged into a circuit that can carry the load.
Watch out: a space heater placed in a closed closet or crawl space with no ventilation can overheat and start a fire. If you cannot safely reach the pipe, insulate it and drip the faucet instead.
What the Local Climate Means for Your Timeline
Freeze risk here is driven by overnight lows, not by the season. A single night in the upper 20s is enough to freeze an exposed line, and the damage often shows up during the thaw the next morning, when water starts moving again and finds the split.
A common pattern is a homeowner who protects the house but forgets the detached garage, the well house, or the irrigation line. Treat every unheated structure on the property as a freeze risk, and put the most vulnerable pipe on your drip list before the first cold night of the year.
Booking a Plumbing Inspection Before the Cold Arrives
A plumber can spot weak points you might miss, such as small cracks, failing insulation, or pipes routed through poorly sealed spaces. An inspection before the first hard freeze is far cheaper than repairing water damage after a burst.
PUR Plumbing offers booking a plumbing inspection to check for freeze risks before winter for homes and businesses across Pasco County. If you think a leak or hidden damage may already exist, learn how to tell if you have a slab leak before the cold makes it worse.
Ask about the inspection scope before booking, including whether it covers exterior lines and any unheated areas.
Frequently Asked Questions
At what temperature will pipes in a house freeze?
Pipes are at risk once outdoor temperatures drop to around 20 degrees Fahrenheit and stay there for several hours, though pipes in exterior walls, garages, crawl spaces and attics can freeze sooner. Keeping indoor air at or above 65 degrees Fahrenheit helps protect plumbing, and most households in Pasco should watch the overnight forecast rather than the daytime high. If the forecast shows a hard freeze, take preventive steps even if the house feels warm.
How many faucets should I let drip to prevent pipes from freezing?
Open one faucet on each exterior-facing or cold-exposed line, usually a kitchen tap and a bathroom tap on the far side of the house, and let it drip slowly, not run at full pressure. Moving water is less likely to freeze, and the drip relieves pressure if ice forms. Dripping alone does not guarantee protection, so combine it with thermostat settings and insulation.
Will shutting off the water keep pipes from freezing?
Shutting off water to exterior spigots and hose bibs helps, because it lets you drain and disconnect the line before it freezes. Shutting off the main supply to the whole house is only useful if you can drain the system afterward, since standing water left in lines can still freeze. If you are unsure where your main shut-off valve is, locate it now so you can act quickly in an emergency.
What should I do if a pipe freezes but has not burst?
Do not use an open flame to thaw a pipe. Open the nearest faucet so water can flow once the ice melts, then warm the section with a hair dryer on low heat or heat tape, working from the faucet end toward the frozen spot. If the pipe has already split or water is leaking, shut off the main valve and call a licensed plumber right away.


